Standard Engine Pipe - Hyundai Getz TB 1.3L 1.5L Hatch (2002 - 2005) REDBACK Item No: E6282. RRP $204 $185. Make 4 interest-free payments of $46.25 fortnightly and receive your order now. Add to Cart. Hyundai Getz Hyundai Getz Engine Wiring Diagram - Wiring Diagram The Hyundai Getz is a high-roof, front engine, with a large front-drive five passenger supermini manufactured and marketed by Hyundai from 2002 to 2011 in three and five-door hatchback body styles over a single Engine Diagram Hyundai Getz - Orris Loosen the tensioner bolt 1–2 turns and tighten the timing belt to a tension of 57–84 lbs. (260–380 N). Turn the crankshaft two turns clockwise. Readjust the sprocket timing marks and tighten the tensioner bolts. Install the timing belt covers. Install the crankshaft pulley and tighten to 108–116 ft. lbs. (150–160 Nm). This is a follow on from the last video in which I serviced the car. It ran perfectly at idle speed, but under load, it started to misfire and wouldn't pull 31) check engine indicator control 0.3W (cel) 32) sensor power 5v 0.5G/B (tps)(acs) 33) sensor power (maf) 0.5R/O & sensor power (map) 0.5L/O 34) sensor power "B" 0.3W (cps) 35) sensor ground 0.5B (O2 sensor down, engine coolant temp sensor & sender) 36) sensor ground 0.5B (O2 sensor up, maf, map) 37) (maf)afs signal 0.5L (map) map signal 0.5L posted 2015-Mar-23, 12:59 pm AEST. O.P. Hi All, I have a Hyundai Getz 1.4 manual, that usually drives pretty fine. On Friday last week, I started the car in the morning to go out and it started normally – drove for about a 100 meters where I had to stop to get the security door opened. After the brief stop, when I tried to shift it into gear AXin3U. Tue 11 Nov 2014 21:31. Hyundai Getz - engine management light - superad. Just bought a 2004 1.3 gsi with 20k miles on. The check engine management light has started to flash occasionally when accelerating at low revs and the car Judders. The light then goes off and the car drives as it should again. Otherwise the car is very smooth and mint. Gearbox construction: Manual, Automatic. Transmission type: 5 MT, 4 AT. Average acceleration: 12 s to 60 mph. Average optimal engine speed: 5133 rpm. Average torque: 155 Nm. Weight to torque ratio: 7 kg to 1 Nm. Average weight: 1025 kg / 2260 lbs. Maximum load for transmission: 1475 kg / 3252 lbs. Gearboxy rating: 2 / 10. Wiring diagrams for engine management, ABS, ESP and air conditioning; Retrieve data from the vehicle’s engine management/ CAN-Bus system to diagnose faults and component errors which have generated fault codes; Enter fault codes and see their description with suggested components to test; Comfort Wiring Diagrams More about Hyundai Getz fuses, see our website: The crank sensor goes in the back of the engine, very close to the transmission mount. In any case, the crank sensor is either activated by a magnet in the main flywheel or one of the lobes in the crankshaft. That is BEHIND the engine. The timing belt and all the pulleys are IN FRONT of the engine.

hyundai getz 1.3 engine diagram